美孚拉瑪524防銹油(Mobilarma 524)

美孚拉瑪524防銹油(Mobilarma 524) Mobilarma 500 Series oils are premium performance products primarily intended as run-in or lay-up lubricants, which provide effective rust preventive films on the internal surfaces of machinery. They are particularly suitable as run-in lubricants for diesel and gasoline engines. The oils displace water from metal surfaces and form strong water-resistant films on the metal surfaces to prevent rust and corrosion. The Mobilarma Series oils absorb the water in systems into a water-in-oil emulsion so that the contact surfaces of the machinery still get satisfactory lubrication. Their high level of chemical stability and their anti-wear and detergent properties make them suitable as high quality short-term lubricants.


美孚拉瑪524防銹油(Mobilarma 524) In most applications, the residual rust preventive films need not be flushed away when the assembly is filled with lubricating oil or hydraulic fluid and put back in service. However, flushing with a charge of lubricating oil to remove the Mobilarma product or its residual film, is recommended if:


1. The Mobilarma does not provide the required lubricant characteristics to operate the equipment at rated loads and temperatures
2. Draining of the equipment is difficult and considerable pockets of the Mobilarma cannot be easily removed
3. Contamination of the system oil by the Mobilarma could reduce the lubrication performance characteristics (examples; Mobilarma could increase Freon cloud points in compressors or water-in-oil emulsions reduce anti-wear characteristics in high pressure hydraulic systems)
4. Presence of the rust preventive agents reduces the ability of the new oil to separate water in turbine and similar equipment.


Features and Benefits
The Mobilarma 500 Series oils provide an excellent lubricant that also acts as a rust preventive. This allows safe lay-up of equipment that will not be used immediately but may be operated intermittently at low to moderate loads for short periods of time. These products provide excellent rust preventive performance reducing any potential damage that could otherwise occur in non-operating equipment. This saves clean-up and potential rigorous flushing procedures prior to placing the equipment back in service.


Features Advantages and Potential Benefits
Excellent Rust and Corrosion Protection High level protection against rust during seasonal lay-ups
Reduced clean-up time required to place equipment back into production
Displaces water from metal surfaces and form tenacious protective films
Effective Anti-Wear Properties Protects equipment against wear
Dual Purpose Lubricant/Rust-Preventive Nature Reduced costs and time for run-in, testing or adjustment procedures
Eliminates unnecessary flushing and draining steps


Applications
Run-in oil and lay-up oil for engines and industrial equipment
Turbines that will be out of service for long periods
Hydraulic systems where water is present and the formation of emulsions will not effect operation
Test calibration oil


--Typical Properties
Mobilarma 500 Series 522 524 525
Viscosity, ASTM D 445  
cSt @ 40o C 28.8 88.4 53.5
cSt @ 100o C 5.0 10.5 8.7
Viscosity Index, ASTM D 2270 95 95 100
Pour Point, oC, ASTM D 97, max -24 -18 -36
Flash Point, oC, ASTM D 92, min 182 218 198
Density @ 15.6o C, Calculated, lbs/gal 7.3 7.36 7.33


Health and Safety
Based on available information, this product is not expected to produce adverse effects on health when used for the intended application and the recommendations provided in the Material Safety Data Sheet (MSDS) are followed. MSDS's are available upon request through your sales contract office, or via the Internet. This product should not be used for purposes other than its intended use. If disposing of used product, take care to protect the environment.

防銹潤(rùn)滑劑

包裝：18L,208L

上一篇:美孚拉瑪798防銹油 美孚防銹油798 Mobilarma 798

下一篇:美孚拉瑪ST防銹油 美孚雙字母防銹油 Mobilarma ST